Resetting A Picture Profile; Storing A Picture Profile On An Sxs Memory Card - Sony PMW-EX1R Operating Instructions Manual

3
Specify the target picture profile.
"Execute" and "Cancel" are displayed.
4
Select "Execute."
Copying begins.
When copying ends, the completion message is
displayed for three seconds, and the original
screen display is restored.

Resetting a Picture Profile

You can reset a selected picture profile to the
factory settings (standard status).
1
Select the picture profile you wish to
reset by proceeding from step 1 to 3 of
"Selecting a Picture Profile using the
PICTURE PROFILE menu" on page 84.
2
Select "Reset" from "SET" of the
PICTURE PROFILE menu.
"Execute" and "Cancel" are displayed.
3
Select "Execute."
Resetting begins.
When resetting ends, the completion message is
displayed for three seconds, and the original
screen display is restored.
Storing a Picture Profile on an SxS
Memory Card
A picture profile can be sent to and stored on an
SxS memory card as a file (filename:
PPDATA.SUF).
Only one picture profile can be stored on the same
memory card. The stored picture profile can be
immediately reproduced by reading from the
memory card.
Storing a Picture Profile
1
Set the power switch to CAMERA.
The camcorder is turned on in Camera mode.
2
Insert a recordable SxS memory card
into a slot.
Confirm that the corresponding ACCESS
lamp is lit in green.
3
Select the picture profile to be stored.
The selected picture profile number is
displayed at the bottom of the screen.
See "Selecting a Picture Profile using the
PICTURE PROFILE menu" on page 84.
4
Select "SET" of the PICTURE
PROFILE menu.
5
Select "Store" of "PP Data."
PICTURE PROFILE
PP1: STANDARD
SEL
Black
SET
Black Gamma
Low Key Sat
Copy
PP Data
Reset
The message "PP Data Store Execute/
Cancel" is displayed at the bottom of the
screen.
6
Select "Execute."
Writing of the selected picture profile to the
memory card begins.
When writing ends, the completion message is
displayed for three seconds, and the original
screen display is restored.
Note
After you start writing, do not remove the SxS
memory card until the completion message is
displayed.
Loading a Picture Profile
1
Set the power switch to CAMERA.
The camcorder is turned on in Camera mode.
2
Insert the SxS memory card that
contains the picture profile to be loaded
into a slot.
Confirm that the corresponding ACCESS
lamp is lit in green.
: 0
: 0
: 0
B
B
S t o re
Reca l l
Picture Profiles 85