Sony PMW-EX1R Operating Instructions Manual page 55

Zoom speed switch
Power zoom lever
HD V/D
V
BA TT
ER Y
RE LE
AS E
SD I OU
T
ZOOM
MANUAL SERVO
To adjust with the power zoom lever on
the grip
Press the W (wide) side for a wider angle or the T
(telephoto) side for a closer angle.
Pressing the lever deeper sets zooming faster.
To adjust with the ZOOM button on the
handle
Press the W side for a wider angle or the T side for
a closer angle.
Zooming is activated at the speed selected with
the speed switch.
The zoom speed assignment can be changed with
"Zoom Speed" (page 123) of the CAMERA SET
menu.
Speed ZOOM button operation
switch
H Zoom changes with the speed set by
"High" of "Zoom Speed" of CAMERA
SET menu. (Default: 70)
L
Zoom changes with the speed set by
"Low" of "Zoom Speed" of CAMERA
SET menu. (Default: 30)
OFF Disabled.
ZOOM button
REC
START/STOP
T
W
HOLD
H
L
OFF
ZOOM switch:
SERVO
Note
Zoom operation is guaranteed with the zoom
speed settings from 8 to 99.
Zooming may not operate smoothly if you select
a low speed.
To select the operation at the beginning and the
end of zooming
You can select Soft mode for zooming, in which
the zooming speed is gradually increased at the
beginning then gradually decreased for the end.
Use "Zoom Trans" (page 124) of the CAMERA
SET menu.
Zoom Operation at the beginning and
Trans the end of zooming
setting
Linear Zooming immediately begins at the
(Default) specified speed when the ZOOM button
is pressed and immediately ends when
the button is released.
Soft
Zooming gradually increases the speed
up to the specified speed after the ZOOM
button is pressed and gradually decreases
the speed and ends after the button is
released. (1 second at maximum from
when the button is released till the
operation ends.)
Note
If "Zoom Speed" is set to a value less than 20, the
operation becomes the same as "Linear," even
when "Soft" is selected.
When adjusting with the ZOOM button of
the IR Remote Commander
The zooming speed depends on the "Remote"
setting (default: 50) of "Zoom Speed" of the
CAMERA SET menu.
Note
Zoom operation is guaranteed with the zoom
speed settings from 8 to 99.
To use the IR Remote Commander, see "Using the IR
Remote Commander" on page 32.
When using a lens remote controller
Zooming can also be controlled from an optional
lens remote controller connected via the LENS
REMOTE connector.
Adjusting the Zoom 55