Sony PMW-EX1R Operating Instructions Manual page 140

Note
If input/output at the i.LINK (HDV/DV)
connector are enabled (page 143), no signal is fed
out from the SDI OUT connector.
COMPONENT OUT connector (mini-D
connector)
The connector is set at the factory to output HD
analog component signals for monitoring.
When you set the camcorder to SD Mode, the
connector outputs SD analog component signals.
Using "Output Select" (page 128) of the VIDEO
SET menu, you can change the setting so that it
outputs down-converted SD analog component
signals for monitoring even in HD Mode. (The
HD/SD switching becomes valid also on the SDI
OUT connector in synchronization.)
Use the supplied component video cable for
connection.
To display the menus and status information on
the connected monitor
Set "YPbPr/Digital Out Display" (page 128) of
the VIDEO SET menu to "On."
HDMI OUT connector (Type A connector)
Signal output from this connector is enabled by
setting "Output Select" (page 128) of the VIDEO
SET menu.
In HD Mode, you can select HD HDMI, SD
HDMI interlace, or SD HDMI Progressive
output.
In SD Mode, only an SD HDMI interlace signal
can be output.
Use a commercially available HDMI cable for
connection.
To display the menus and status information on
the connected monitor
Set "YPbPr/Digital Out Display" (page 128) of
the VIDEO SET menu to "On."
A/V OUT connector (audio/video
composite multiconnector)
When "Output Select" (page 128) of the VIDEO
SET menu is set to "Composite," the connector
outputs 2-channel audio and down-converted SD
analog composite signals for monitoring.
Use the supplied AV connection cable for
connection.
140 Connecting External Monitors
To display the menus and status information on
the connected monitor
Set "Video Out Display" (page 128) of the
VIDEO SET menu to "On."