Operation; Gobos; Included Gobos; Changing Gobos - Chauvet LFS-5D User Manual

O
PERATION

Gobos

Included Gobos

Changing Gobos

Gobo Access
Diagram
LFS-5D User Manual Rev. 1
Gobos make patterns in the light and can be customized for special events. The LFS-5D uses
V size gobos, which are gobos that have a 25.4 mm outside measurement, a 19 mm image
size and a 1 mm maximum thickness.
The following gobos are included, but any gobo of the correct size can be used.
To change the gobos in the LFS-5D, do the following:
1. Turn off and disconnect the product from power.
2. Place the product on a flat, level surface.
3. Loosen the gobo access door knob.
4. Remove the gobo access door by pressing the knob towards the body of the light and
gently popping the short edge of the door up.
5. Pull the gobo holder out of the gobo slot.
6. Gently pry the gobo holder open so the gobo falls out.
7. Keep the gobo holder pried open and insert a different gobo making sure that the gobo sits
in the center of the gobo holder.
8. Slide the gobo holder back into the gobo slot.
9. Replace the gobo access door by putting the wider edge in place and then using the knob
to press the narrow edge down until the door clicks into place.
10. Tighten the gobo access door knob.
Body Of The Light
Gobo Slot
Long Edge

Operation

Knob
Short Edge
Gobo Holder
Part Of Gobo Holder
To Pry When Opening
The Gobo Holder
Gobo
Page 9 of 14