Id Addressing; Operation; Control Panel Description; Control Options - Chauvet COLORado 1 Tour Quick Start Manual

Operation

4. Operation
Control
Panel
Description
Control
Options
Basic
Programs
DMX
Personality
DMX Control
Without ID
Addressing
DMX Control
With ID
Addressing
Master/Slave
8
B F
UTTON UNCTION
<MENU> Exits from the current menu or function
Enables the currently displayed menu or sets the currently
<ENTER>
selected value into the current function
Navigates upwards through the menu list and increases
<UP>
the numeric value when in a function
Navigates downwards through the menu list and
<DOWN>
decreases the numeric value when in a function
You can set the COLORado™ 1 Tour start address in the 001~512 DMX
range. This allows for the control of up to 56 fixtures in the 11-channel
TOUR personality. In addition, the ID address system allows you to assign
up to 66 fixtures within the same DMX address, thus multiplying the number
of fixtures you can control within a single universe. You can access the
fixture's ID address system from channel 11 when in the TOUR personality.
To remain within a one-second execution time, program no more than
10 fixtures on ID addressing per DMX channel.
Carry out all the programming procedures indicated below from the control
panel. Refer to the Menu Options on page 9 to learn how the menu options
relate to each other. Download the COLORado™ 1 Tour User manual for
more programming instructions.
1) Go to MENU > PERS and select any DMX personality.
2) Make sure to rearrange the DMX addresses of all fixtures in the current
DMX universe to avoid address overlapping.
1) Select the DMX personality as explained in DMX Personality.
2) Go to MENU > RUN and select DMX.
3) Go to MENU > DMX and select a starting DMX address (001~512).
4) Go to MENU > SET > ID and select OFF.
Make sure to disable ID Addressing on all fixtures and to set DMX
channel 11 to 0 when in the TOUR personality.
1) Repeat steps 1 to 3 from DMX Control Without ID Addressing.
2) Go to MENU > SET > ID and select ON.
3) Go to MENU > ID and select an ID address (1~66).
On the Master unit:
1) Go to MENU > RUN and select DMX.
2) Go to MENU > AUTO and select any Auto program.
On each of the Slave units:
1) Go to MENU > RUN and select SLAVE.
COLORado™ 1 Tour Quick Start Guide Rev. 03