3.4 Removing a Splitter Chassis Card
Use the following procedure to remove a splitter card from the IES-2000 splitter chassis.
Disconnect the cable from the card.
Step 1.
Loosen the two thumbscrews.
Step 2.
Grasp the handles on the front panel of the card and start to pull the card out.
Step 3.
After you have the card partially out of the chassis, place one hand under the card to support it.
Step 4.
Slide the card out of the slot.
Step 5.
Card Installation
Figure 3-9 Loosening Splitter Chassis Card Thumbscrews
Figure 3-10 Removing a Splitter Chassis Card
IES-2500 User's Guide
3-5