Figure 5-7 Installation Scenario C - ZyXEL Communications IES-2500 User Manual

IES-2500 User's Guide
User A still has telephone service only. User B now has telephone and DSL service (see the
Procedure to Connect to MDFs
Connect the Telco-50 connector end of the cable you want for DSL service to the Telco-50
Step 1.
connector labeled USER on the splitter chassis rear panel.
Connect the wiring on the other side of the Telco-50 cable to the upper ports of MDF 3 using a
Step 2.
punch-down tool.
Connect the lower ports of MDF 3 to the upper ports of MDF 2 for those users that want DSL
Step 3.
service. (Users who want telephone service only, retain the original connection from the top port of
MDF 2 to the bottom port of MDF 1.)
Connect the telephone wiring from the end-user's DSL equipment to the lower ports of MDF 2.
Step 4.
Connect the Telco-50 connector end of the cable you want for phone service to the Telco-50
Step 5.
connector labeled CO on the splitter chassis rear panel.
Connect the wiring on the other side of the Telco-50 cable to the lower ports of MDF 4 using a
Step 6.
punch-down tool.
Connect the top ports of MDF 4 to the bottom ports of MDF 1 using telephone wires.
Step 7.
Connect the top ports of MDF 1 to the telephone company.
Step 8.
5-6
following figure)

Figure 5-7 Installation Scenario C

MDF Connections