System Update - Wirepath Surveillance WPS-500-PTZ-IP Installation And User Manual

WPS-500-PTZ-IP Installation Manual

12.3- System Update

Important Note:
Updating Firmware MUST be performed over a wired IP connection to the device. While it is possible to recover from an
upgrade that fails due to a lost or intermittent connection, the camera will be inoperable until it is recovered via a reliable
connection.
Pg. 30
Recommendation: Before performing a Firmware update, we recommend that the Cameras configuration
be saved to a file in the event that any settings are changed by the upgrade.
Firmware Version
Current firmware version of the Cameras.
New Firmware Select Browse to open a new firmware file stored on the PC. After selecting the
file, select the Upgrade button to begin the firmware update process. Software
Updates can be downloaded from www.SnapAV.com.
Reboot System
Select the Start button to reboot the Cameras.
Factory Default Select the Start button to reset the Cameras to factory defaults.
Recommendation: This will erase all camera settings with the exception of
network configuration and User accounts. However, as a precaution we
recommend that the settings are saved prior to performing a factory default.
Load Settings File Allows for a previously saved setting file to be uploaded to the Cameras.
Note: This will overwrite any existing settings once Apply is selected.
Backup Settings Saves the current settings to a backup file. Select the Download button and
select the desired file path and name.
© 2013 Wirepath™ Surveillance