1-Recommendations For Best Performance; Live View Controls; 1-Top Of Screen - Wirepath Surveillance WPS-500-PTZ-IP Installation And User Manual

Ip ptz camera
Table of Contents

Advertisement

WPS-500-PTZ-IP Installation Manual
6.1.1- Recommendations for Best Performance
As the number of open browser windows or tabs increases, the risk of slowed response time to the cameras increases. We
recommend that open browser windows or tabs be limited to no more than 4 to avoid interruption in communications or reduced
response time with the cameras.
Due to the limited upload speeds set by ISP (Internet Service Provider) we recommend that Streaming 2 is selected when viewing the
cameras remotely (outside the local network) as the lower resolution provides better frame rates allowing for a smoother video
stream.

6.2- Live View Controls

6.2.1- Top of Screen
1
2
3
4
1.
Video
Expands the camera's image to full screen. Press ESC or double click on full screen image to return to Live View screen.
2.
Digital Zoom
A.
Select the checkbox to enable Digital Zoom.
B.
Move the slider to the desired zoom level.
C. Click and drag on the green box in the preview window to select a desired location to view.
D. Click on the X in the upper right hand corner to close the Digital Zoom window.
Note: The Live View video will remain at this zoom level and area selection only for the current viewing session. When
the user leaves Live View for any reason, zoom level will be reset to 100%.
3.
Audio Out
Mutes or Un-Mutes Audio to a speaker connected to the Camera, if installed.
4.
Audio In
Mutes or Un-Mutes Audio from the microphone connected to the Camera, if installed.
5.
Record
Records the current live stream to an .AVI video file in the selected location on the PC or network. A dialog window opens
prompting for the storage location. Press Record Stop in the dialog window to stop the recording.
Note: The quality of this recording will vary based on the bandwidth of the connection to the camera and the processing
power of the local computer.
6.
Photo
Takes a JPEG snapshot of the current image that can be saved to the PC.
7.
PTZ
Opens panel to control the functions of a PTZ NVR.
See section
8.
Config
Opens the Camera's configuration menu.
Pg. 12
5
6
7
8
6.3-PTZ Controls
© 2013 Wirepath™ Surveillance

Advertisement

Table of Contents
loading

Table of Contents