Table of Contents
Advertisement
A.5- If HTTPS access is desired, repeat step B entering a port next to HTTPS Port.
A.6- Click Apply at the bottom to save the settings.
B.
Select a DDNS Service
See section
B.1- Select PPPoE & DDNS under the Network section of the left side Menu.
B.2- Under DDNS Setting, Select Enabled.
B.3- Select the DDNS Provider in the dropdown list.
B.4- Enter a Hostname to use for Remote Access to the Cameras(s).
Example: JonesHouse
B.5- Click Apply at the bottom to save the settings.
Note: If installing multiple cameras, this step only needs to be completed once. After that, each Wirepath™
Surveillance camera can be accessed using the same Hostname and each camera's uniquely assigned port number.
Example: joneshouse.WirepathDNSWirepathDNS.com:8201 accesses one camera,
joneshouse.WirepathDNSWirepathDNS.com:8202 accesses another, etc.
C. Configure Router for Port Forwarding.
In order to access the Camera(s) from outside the network, the assigned port must be forwarded within the network's
router. User interfaces and methods for port forwarding varies from router to router, refer to the manual for the router
being used for information on how to forward ports. If the router supports UPnP Port Forwarding, the camera can be
configured to use this feature from the camera interface. See section
Settings.
www.snapav.com Support: 866.838.5052
12.6.2-DDNS Settings
for details on the features used in this step.
WPS-500-PTZ-IP Installation Manual
12.4.2-Port Assignment
and section
12.4.3-UPnP
Pg. 27
Advertisement
Table of Contents
