6- Main Camera Interface; Accessing The Camera - Wirepath Surveillance WPS-500-PTZ-IP Installation And User Manual

6- Main Camera Interface

Note: The camera requires configuration before accessing for the first time. See sections
Initial Configuration

6.1- Accessing the Camera

Note: IE 8.0 or higher is required to access the camera; other browsers are not supported at this time.
A. Open the web browser, and enter the IP Address that was assigned to the camera. The address should include the
port number assigned to the camera. Note that access varies between local network and remote access through a
DDNS.
Local Network Example:
Remote Access (DDNS) Example:
B. A window will open asking for a username and password.
Default Username and Password:
Username:
Password:
Recommendation: After initial setup of the Cameras, we recommend that the password be changed to avoid
unwanted access.
C. Install the ActiveX control if prompted to do so.
D. After installing the ActiveX the camera should be visible in the web browser, if the camera does not appear, verify the
IP address by using the IP Installer.
www.snapav.com Support: 866.838.5052
before opening the browser.
admin
admin
http://192.168.1.56:8056
http://JonesIPCamera.Wirepathdns.com:8056
WPS-500-PTZ-IP Installation Manual
9-IP Installer Software and 10-
Pg. 11