Dhw Quick Heat-Up; Energy Saving Mode (No Function); Active Cooling - Wolf BWL-1 S Installation And Operating Instructions Manual

29.4.4 DHW quick heat-up

Setting range: Off, On
Factory setting: Off
If this parameter is set, the DHW temperature is controlled once to the set value using all available heat sources. The parameter
is then automatically reset.
Main menu
Main menu
← back
Displays
Default settings
Contractor
← back
29.4.5 Energy saving mode
No function

29.4.6 Active cooling

Setting range: Off, On
Factory setting: Off
Enables the user to activate/deactivate active cooling.
This requires that the system is configured with active cooling and that active cooling is enabled via contractor parameter
WP058 (factory setting: Off).
During active cooling, the cooling capacity of the heat pump is transferred to the heating system.
Main menu
Main menu
← back
Displays
Default settings
Contractor
← back
Config.
Cooling
1, 5, 14,
15, 51
3064298_201507
29. Operating the AM display module
Submenu
Default set.
← back
Key lock
DHW op mode
DHW quick heat-up
← back
Submenu
Default set.
← back
DHW quick heat-up
Energy saving mode
Active cooling
← back
Yes Yes
WP058
ON
Yes
Outside temp.
Default setting
>
Act. cooling
WP053
Menu item
DHW quick heat-up
ON
Menu item
Active cooling
On
Cooling deactivated
Yes
BM-2/AM
Cooling active
On
55