Table of Contents
Advertisement
STARTING AND USE
INSTALLING THE CHAIN GUIDE
2 types of chain guide bar can be mounted on the chainsaw:
standard 12'' guide bar (ref. 72884)
carving 12'' guide bar (ref. 80344).
Do not use other chain guide bar than those recommended.
Follow the chain installation procedure.
Replace the chain guide or turn it round if necessary.
The chain guide must be replaced whenever necessary
or when 3 or 4 chains have been replaced. Turn the
chain guide round every week.
Always set the switch to the off position «0» and disconnect
the battery connector before doing any work.
INSTALLING THE CHAIN
(P/No. 81794).
Remove the chain guard by unscrewing the chain guard (10)
lock.
Push the guide towards the sprocket to enage the lock.
Install the chain in accordance with the cutting direction.
Reinstall the chain guard.
Adjust the tension of the chain.
Always set the switch to the off position «0» and disconnect
the battery connector before doing any work.
AUTOMATIC CHAIN TENSIONING
Simplified chain maintenance!
No need for an additional wrench to remove and reinstall the
chain, PELLENC's innovative retractable wrench system can
be used to tighten the chain in a few seconds.
Loosen the chain guard (10) nut by 3 turns.
The chain is tensioned automatically when the guide moves
forward.
Tighten the chain guard nut correctly using the telescopic
wrench and put the wrench handle back on its magnetic
holder.
16
51_08_028A
51_08_029A
51_08_033A
Advertisement
Table of Contents
