PUTTING THE TOOL INTO SERVICE
CHAIN LUBRICATING SYSTEM
Reasonable oil consumption!
Oil consumption has been significantly reduced by the
electronic control of the oil flow. This is a PELLENC
innovation.
1– Use special guide and chain oil (P/No. 85920).
2– Carefully pour the guide and chain oil into the reservoir.
3– Check the oil level every hour and top it up if necessary.
COMMENT:
PELLENC recommends using biodegradable chain oil in
compliance with RAL-UZ-48 norm (ref. 85920 or, by default,
any oil in compliance with RAL-UZ-48 norm)
FORCED CHAIN LUBRICATING SYSTEM
1– Press the triggers and keep them hold.
2– Set the battery switch to «I».
3– An automatic cycle starts which sends oil from the
reservoir to the chain guide.
- 1 short beep every 20 seconds during the cycle.
- 3 beeps to validate the end of the cycle.
4– Loosen the triggers when you hear the first beep.
CAUTION:
G
Carry out forced lubrication at the start of each season
in order to check the chain lubricating function.
Carry out forced lubrication when necessary.
CHAIN PROTECTION
Fit the guide and chain protection whenever you transport,
handle and store the chain saw.
Never transport the chain saw without its
protective cover. The chain saw must always have
its protective cover on when moved.
CAUTION: Never use dirty or used oil.
G
13
51_08_020A
51_08_021A
51_14_004A