GENERAL INSTRUCTIONS FOR SHARPENING THE CUTTERS
SHARPENING THE CUTTERS USING A ROUND FILE
As shown on the diagram, place a file holder on the top
platen and the depth limiter of the cutter.
Sharpen the cutters from one side of the chain by filing
from the interior toward the exterior. File only by pushing.
Hold the mark on the file holder parallel with the mark on
the platen. Proceed in the opposite manner for the other
side.
If the side platen or the top platen is damaged, file until
this part is removed.
All the cutters must be the same length.
File holder
interior
A
21
Direction to be followed
=1/5 of the Ø or 20%
above the platen
exterior
A = B
B