Table of Contents
Advertisement
PUTTING THE TOOL INTO SERVICE
STARTING
1– Put the tool in its starting position (see page 20). Remove the
chain guide protector.
2– Set the battery On/Off switch. to the on position «I». From
the moment the indicator light (18) comes on and the
battery emits 3 beeps, the tool is energized and ready to
operate.
3– Press and hold the safety trigger (3) while holding the
chainsaw by the upper handle.
4– In order to guarantee chainsaw safety when relocating, an
electronic device blocks the motor control 3 seconds after the
motor is stopped. Press the trigger (2) twice consecutively to
restart the motor. The chainsaw runs by keeping at least the
trigger (2) pressed.
5– Release the trigger (2) to stop the motor.
The light on the handle indicates that the power supply is switched on.
CAUTION:
G
When either the guide or the chain is replaced, they must be run in by operating the tool off load
for 1 to 2 minutes.
Check the chain tension after running in (see page 23).
The tool is equipped with a Pellenc-designed electric motor. The motor maintains a constant
speed, both off load and when cutting.
Allow the chainsaw to cut without pressing excessively.
Always start the motor before bringing the chainsaw into contact with the wood.
To prevent the motor from overheating, alternate between large cuts and small cuts.
HOLDING THE TOOL
1. Take the chain saw by the handles and ensure nothing is
touching the chain.
2. Attach the power supply cord to your arm using the
supplied armband.
3. The chain saw is in its "start-up" position.
CAUTION! Do not cut anything other than wood.
Always keep both hands on the handles.
CAUTION:
G
Never disconnect the power lead from the battery
without checking that the On / Off switch is in the off
position «0».
14
18
2
3
51_08_024C
51_08_023B
Advertisement
Table of Contents
