Kyocera KM-3035 Operation Manual page 32

Section 4 BASIC OPERATION
9
9. At the end of copying
Finished copies will be ejected onto the copy store section.
IMPORTANT!
• Up to 250 copies can be stored on the copy store section.
• If "The output tray exceeds capacity. Remove the paper." ["Too much
paper in output tray. Remove paper."] is displayed, there are too
many copies on the top tray. Remove the copies from the copy store
section and then press the [Start] key to resume copying.
• If ejected copies come out curled, or are otherwise not stored
cleanly, remove the paper from the drawer[cassette] or the multi-
bypass tray (whichever is currently being used), turn the paper over,
set it again in that location and try to copy again.
CAUTION
If the copier will not be used for a short period of time
(overnight, etc.), turn the main power switch OFF (O).
If it will not be used for an extended period of time
(vacations, etc.), remove the power plug from the
outlet for safety purposes during the time the copier
is not in use.
IMPORTANT!
(For metric specification copiers)
If you turn the main power switch OFF (O) or remove the power plug
from its outlet when the optional Printer Kit, Printer/Scanner Kit or Fax
Kit is installed on your copier, the corresponding print out and fax
communication operations will not be possible. To keep those
functions enabled, press the [Power] key to put the copier into the
Sleep mode rather than turning the main power switch OFF.
4-4
NOTE
Metric specification copiers have a main power switch cover.