Kyocera KM-3035 Operation Manual page 144

Section 8 MAINTENANCE AND OPERATION INFORMATION
16 Gently pull out the cleaning shaft (with the green handle) as
far as it will go and then push it back into the copier.
Repeat this step a few times.
1
IMPORTANT!
Do not pull the cleaning shaft with force or pull it out completely.
17 Remove the blue cleaning brush.
18 Pull up the left cover 1 handle to open the left cover 1.
8-6
2
19 Clean the separator by moving the cleaning brush from left
and right several times along the separator as shown in the
illustration.
20 Once the cleaning operation is completed, return the
cleaning brush to the copier and close both the left cover 1
and the front cover.
IMPORTANT!
Wait about 5 minutes after the cleaning operation is completed for the
electrostatic section to dry before attempting to start copying again.
NOTE
To keep the best copying quality, perform cleaning of steps 15 and 18
described above periodically (approximately once a month) in addition
to the time of toner container replacement.
● After use, ALWAYS dispose of the toner container
and the waste toner box in accordance with
Federal, State and Local rules and regulations.