Download  Print this page

Changing Needle; How To Use The Needle Threader/holder - ELNA 444 Instruction Manual

Hide thumbs

Advertisement

w
e
t
r
q
y

Changing Needle

WARNING:
Turn the power switch off and unplug the machine
before changing needles.
Turn the handwheel toward you to raise the needle to its
highest position.
q Handwheel
Then loosen the needle clamp screw for the needle you
are going to remove.
w Needle clamp screw
e Small screwdriver
Insert a new needle into the needle clamp with the flat
side to the back and push it up against the stopper, then
tighten the needle clamp screw.
r Flat side
t Stopper

How to use the needle threader/holder

To attach the needle easily, use the end of the needle
threader to hold the needle.
Insert a needle into the needle threader/holder with
the flat side facing back as shown.
Hold the stem and insert the needle into the needle
clamp and push it up as far as it will go.
Tighten the needle clamp screw firmly while supporting
the holder in place.
Pull the holder down to remove it.
y Needle threader/holder
NOTES:
Use Organ needles EL X 705 size 80/12 or EL X 705
size 90/14.
Do not use any needle which is bent or blunt.
14

Advertisement

Table of Contents

   Also See for ELNA 444

Comments to this Manuals

Symbols: 0
Latest comments: