CARE OF YOUR MACHINE
Cleaning the Feed Dogs and Looper Area
Turn the power switch off and unplug the machine
Do not dismantle the machine in any way other than
what is explained in this section.
z Remove the presser foot and needles.
x Remove the setscrew and needle plate.
c Clean the feed dogs with a lint brush.
w Needle plate
e Lint brush
v Open the looper cover and clean the looper and
surrounding area with the lint brush.
b Replace the needle plate, needles and presser foot.
Close the looper cover.
r Looper cover
Replacing the Light Bulb
Turn the power off before replacing the light bulb.
The bulb could be HOT, wait until it has cooled down
before touching it.
z Remove the setscrew and face plate.
x Push up and twist the bulb counterclockwise (in the
direction "A") to remove it.
Push up and twist the bulb clockwise (in the
direction "B") to replace it.
c Attach the face plate with the setscrew.
w Face plate
e Light bulb