Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Step 1. Prepare Camera for Mounting
Prior to mounting the camera, take into account the angle-of-view limits.
Ensure that the bullet camera can be aimed toward the desired field of
view.
A. Adjust camera rotation
B. Adjust swivel of camera
C. Adjust camera angle
Note: Use the included 3mm Allen key to
make adjustments. Hand tighten only.
Step 2. Connect the Camera to the System
Recommended Cabling:
•
Video - RG59 or RG6
•
Power - Cat5e/6 or 18/2
A. Connect the BNC video output to the video input of a DVR or monitor.
B. Connect the DC Power In to a 12V DC 1A power supply using the included
WPS-ACC-PWR DC power adapter on the wire.
Important Note! If voltage is incorrect or polarity is reversed, the camera will
protect itself and will not power on. If you notice this, disconnect the camera
from the power source immediately and verify if voltage and/or polarity is
correct.
© 2014 Wirepath Surveillance
DC Plug
12V DC Power
BNC Video
Output
WPS-365-BUL-A Installation Manual
A
B
C
5
Advertisement
Table of Contents
