Rc Components; Get The Model Ready To Fly; Check The Control Directions - Hobbico Midi EDGE 540 FLWA4001 Building And Instruction Manual

RC COMPONENTS

Use the attached velcro tape, to fi x the battery inside the body.
Fasten the battery, using Fliteworks battery tape.
To fi x the receiver, you can use double sided adhesive tape.
Please consider the references of your Rx-manual.
This assembly of RC components shows only a possible
sample.

GET THE MODEL READY TO FLY

CHECK THE CONTROL DIRECTIONS

❏ 1. Turn on the transmitter and receiver and center the
trims. If necessary, remove the servo arms from the servos and
reposition them so they are centered. Reinstall the screws that
hold on the servo arms.
❏ 2. With the transmitter and receiver still on, check all the
control surfaces to see if they are centered. If necessary, adjust
the clevises on the pushrods to center the control surfaces.
4 CHANNEL RADIO SETUP
MODE 1
RUDDER
MOVES
RIGHT
ELEVATOR
MOVES DOWN
4 CHANNEL RADIO SETUP
MODE 2
RIGHT AILERON MOVES UP
LEFT AILERON MOVES DOWN
ELEVATOR
MOVES DOWN
❏ 3. Make certain that the control surfaces and the carburetor
respond in the correct direction as shown in the diagram. If any
of the controls respond in the wrong direction, use the servo
reversing in the transmitter to reverse the servos connected to
those controls. Be certain the control surfaces have remained
centered. Adjust if necessary.
RIGHT AILERON MOVES UP
LEFT AILERON MOVES DOWN
CARBURETOR WIDE OPEN
RUDDER
MOVES
RIGHT
CARBURETOR WIDE OPEN
11