EDIT mode Correcting the fullness in the current sewing step
110
Figure 75: Correcting the fullness parameter
Buttons for manually inputting the fullness are displayed in the left
pane.
Symbols/buttons
1. Select the type of fullness.
The type of fullness selected is displayed in an activated
control field within the symbol.
Controller with the OP7000 control panel
Meaning
Input the fullness.
The fullness setting is displayed by a
button highlighted in red.
Select the type of fullness:
• Upper (upper transport)
• Lower (lower transport)
The fullness selected is displayed in an
activated control field.
Display of further buttons for inputting the
fullness. The buttons 0 to 16 are available
for input.
Operating Instructions 650-16 - 01.0 - 06/2014