Dürkopp Adler 650-16 Operating Instructions Manual page 121

Controller with the OP7000 control panel
Mode
PROGRAMMING
Operating Instructions 650-16 - 01.0 - 06/2014
2. If a higher or lower degree of fullness is required, use the arrow
keys to display more buttons.
3. Input the fullness using the buttons 0 to 16.
Other program parameters
After the Other program parameters button has been pressed,
an overview of all the available parameters is displayed.
Figure 83: Other program parameters
Parameters
Backtack at Start
Backtack at End
Thread Trim
Grading Factor
Meaning
Backtack at start of the seam on/off
Value range: 0, 1
Backtack at end of the seam on/off
Value range: 0, 1
Thread cutoff on/off
Value range: 0, 1
Grading factor
Value range: 0.0 ... 6.0 (% per size)
119