6-Port 10Base-T/100Base-Tx Module; Module Panel And The Indicators; Module Interface Cable; 6-Port 100Base-Fx Single Mode/Multi-Mode Module - Huawei Quidway S3000-EI Series Installation Manual

Installation Manual
Quidway S3000-EI Series Ethernet Switches

7.7 6-Port 10Base-T/100Base-TX Module

7.7.1 Module Panel and the Indicators

The panel of 6-port 10Base-T/100Base-TX module is shown in the following figure:
Figure 7-13 6-port 10Base-T/100Base-TX module panel
The descriptions of panel indicators are as follows:
Table 7-14 Meanings of indicators of 6-port 10Base-T/100Base-TX module on the panel
Indicator
ACT/LINK
SPEED

7.7.2 Module Interface Cable

6-port 10Base-T/100Base-TX module interface matches RJ-45 connector and is
connected with Category-5 cable. The module supports MDI/MDI-X auto-sensing
and can operate in auto-negotiation, full-/half-duplex mode. The following table
describes the interface attributes.
Table 7-15 6-port 10Base-T/100Base-TX module interface attributes
Connector
Interface number
Operating mode
Transmission medium and
maximum transmission
distance

7.8 6-Port 100Base-FX Single Mode/Multi-Mode Module

7.8.1 Module Panel and the Indicators
The panel of 6-port 100Base-FX Single Mode module is shown as follow:
Off means that the line is disconnected. On means the line is connected. Blinking means data
is being received or sent.
Off means 10Mbps and on means 100Mbps.
Attribute
RJ-45
6
10M/100M half-duplex
10M/100M full-duplex
Support MDI/MDI-X auto-sensing
Category-5 twisted pair cabling. A maximum transmission distance of 100m is
supported
Chapter 7 Optional Interface Modules
Status description
6-Port 10Base-T/100Base-TX Module
7-11