Boot Menu - Huawei Quidway S3000-EI Series Installation Manual

Installation Manual
Quidway S3000-EI Series Ethernet Switches

5.2.1 Boot Menu

Take S3026C Switch as an example. After being powered on, the switch runs the
BootROM program first and displays the following information on the screen:
Starting...
************************************************
*
*
*
************************************************
Copyright(C) 2000-2003 by HUAWEI TECHNOLOGIES CO.,LTD.
Creation date: June 16 2003, 16:57:31
CPU type
CPU Clock Speed : 150Mhz
Memory Size
Initialize LS66LTSU......................................OK!
SDRAM selftest...........................................OK!
FLASH selftest.............................................OK!
CPLD selftest............................................OK!
Port g1/1 has 1000BASE-SX MM module
Port g2/1 has 1000BASE-T GT module
Switch chip selftest.....................................OK!
Switch SDRAM selftest....................................OK!
PHY selftest.............................................OK!
Please check port leds.......................... ........OK!
The switch Mac is: 00-E0-FC-35-26-E0
Press Ctrl-B to enter Boot Menu... 5
Press <Ctrl+B>. The system displays:
Password :
Note:
To access the Boot Menu, you should press <Ctrl+B> within five seconds after the information "Press
Ctrl-B to enter Boot Menu..." appears; otherwise the system will start to decompress the program. At this
time if you want to access the Boot Menu, you will have to restart the switch.
Quidway S3026C BOOTROM, Version 120
: MIPS
: 64MB
Chapter 5 BootROM and Host Software Loading
5-2
*
*
*