Huawei Quidway S3000-EI Series Installation Manual page 55

Installation Manual
Quidway S3000-EI Series Ethernet Switches
Step 3: Run terminal emulation program on the PC connected to the Console port.
Start the switch, access Boot Menu, and then enter download protocol menu.
To download the BootROM program, press <Ctrl + U> to access the menu for
BootROM downloading when the system displays: "Enter your choice (0-5):"
Enter your choice(0-5):
Please set bootrom download protocol parameter:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Step 4: In the download protocol menu, press <2> to select FTP protocol to download
BootROM and host software. Press <Enter>. The system displays the following
information:
Load File name
Switch IP address ←(That address is in the same network segment as the server IP address)
Server IP address
FTP User Name
FTP User Password ←It must be the same one set on FTP Server
Step 5: Input the FTP parameter values and press <Enter>. The system displays the
following information:
Are you sure to update your bootrom?(Y/N)
Step 6: Press <Y> to start file downloading and <N> to return to the program
downloading menu. Suppose you press <Y> and then <Enter>. The system starts
program downloading and upon its completion, starts writing to Flash. The system
displays the following information after completing the writing operation:
Initializing net....done!
Loading.........................done!
Bootrom is updating now.....................................done!
III. Loading host software
Follow these steps to download the host software:
Step 1: Select <1> in Boot Menu. The system displays the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
You can select a different protocol to download host software.
←It must be the same one set on FTP Server
5-10
Chapter 5 BootROM and Host Software Loading