Cleaning The Circumference Of Print Head - MUTOH Valuevet VJ-1638 Operation Manual

6 Maintenance
8. Press the [Menu] key on Operation panel.
• The printer enters Normal.
• Cleaning Cleaning wiper is complete.
6.2.5

Cleaning the circumference of Print head

This section describes how to clean the circumference of Print head.
(1) Time for cleaning
When foreign substances such as dust or ink clump that can cause missing dots or ink leakage is attached
around Print head
(2) Cleaning procedures
Follow the procedure below to clean the circumference of Print head.
NOTE
• Before cleaning the circumference of Print head, read this procedure thoroughly to fully understand
it, and clean promptly and correctly.
• While cleaning the circumference of Print head, Print head cap is removed, therefore cleaning must
be done before Print head dries.
This operation should be done within 15 minutes.
If the operation lasts over 15 minutes, follow the steps 8 and 9 and stop the operation, pefroem head
cleaning, and resume cleaning.
6.2.3 Head cleaning
• Use Cleaning stick to clean the circumference of Print head.
For details of Cleaning stick, refer to "8.3 Options/Supply list".
1. If the printer is turned ON, make sure the following.
• Printing or other operations are not in progress.
• Operation panel display is Normal.
VJ-1638/1638W OPERATION MANUAL
6-40