HP ProLiant DL580 Maintenance And Service Manual page 71

4. Change POST Speed Up to Disable.
5. Press any key to return to the RBSU main menu.
6. Press the F10 key, when prompted, to exit RBSU. The server reboots and
tests all memory in the system.
7. Once the memory has been tested, re-enable POST Speed Up for faster
system boot, if desired.
ROM-based diagnostics
1. Power on the server.
2. Press the F10 key, when prompted, to enter the System Maintenance menu.
3. Select Diagnostics.
4. Run the Memory Diagnostics.
5. Once the memory has been tested, exit the utility and reboot.
6. Select the AMP mode ("Selecting the AMP mode" on page 71).
Selecting the AMP mode
1. Upon reboot, press the F9 key, when prompted, to enter RBSU.
2. Select System Options.
3. Select Advanced Memory Protection.
4. Select the desired memory mode.
– Advanced ECC (hot-add enabled)
– Advanced ECC (hot-add disabled)
– Online Spare Memory with Advanced ECC
– Hot-Plug Mirrored Memory with Advanced ECC
– Hot-Plug RAID Memory with Advanced ECC
5. Press the Escape key twice to go back to the main RBSU menu.
6. Press the F10 key, when prompted, to exit RBSU. The server reboots and
tests all memory in the system.
Removal and replacement procedures 71