Connecting Twisted Pair Cable / Sfp+ Module - Fujitsu XG0440DC Hardware Manual

XG0440DC/XG0440DCR Hardware Guide
2.3.3

Connecting Twisted Pair Cable / SFP+ Module

Below is how to connect twisted pair cable and SFP+ module.
Use the crossover cable when connecting with routers and terminals. Use the straight cable in case of cascading connection
with other switching HUBs with transmission mode at fixed setting other than auto negotiation.
Management port of the switch is set auto negotiation enable by default.
(However, SFP+ slots only support 10Gbps full duplex mode fixed setting.)
Ports automatically apply to the maximum speed that plugged equipment supports by the auto negotiation function.
• 100BASE-TX port
Connecting Twisted Pair Cable
Insert twisted pair cable to 10/100BASE-TX port until it clicks.
Precautions
• Usable twisted pair cables are unshielded twisted pair cable (UTP) over category 5E and shielded twisted pair cable
(STP).
• Discharge twisted pair cable before connecting as twisted pair cable may be charged static electricity. Refer "2.3.1
Discharging Twisted Pair Cable", p. 33, for discharging method.
straight cable
crossover cable
: Up to maximum 100Mbps full duplex mode
The Management Port is MDI fixed. If a device that has a MDI fixed port is to
be connected to the Management Port, please use a UTP Crossover Cable.
Twisted Pair Cable
35
Chapter 2 Installation
optical cable
Connecting the Equipment