Fantasea Line FRX100 IV Instruction Manual page 7

Numbered descriptions below refer to corresponding numbers on the top/front housing graphic on the
previous page:
1. Zoom Control – Turning this control activates the camera zoom button.
a. In Shooting Mode –
i. Turn the zoom control clockwise to zoom out, increasing the area visible in the frame.
ii. Turn the zoom control counterclockwise to zoom in, so that the subject fills a larger
b. In Playback Mode - use the zoom control as an index or playback lever.
2. Shutter Release – Activates the camera shutter release button and auto focus prior to taking the
picture.
3. On/Off- Pushing this control activates the camera power switch button and turns the camera on/off.
4. Mode Dial – Turn this dial to change shooting modes.
Important Notice! It is recommended to align housing and camera mode dials prior to installing the
camera inside the housing. Please refer to the section "Installing the Camera" for more information.
5. Cold-Shoe Mount for Lighting Accessories- Enables mounting a flash, video light, torch or focus light
on top of the housing by using a dedicated connector. For further information regarding such
connectors, please visit the Fantasea website –
6. Fiber Optic Cable Plate-
a. When installed on the housing, the fiber optic cable plate and the two adaptors inserted
inside it allow for an easy attachment of 2 fiber optic cables to the housing. For further
instructions, please refer to the section "External Flashes".
b. Remove the fiber optic cable plate from the housing in order to make use of the internal
camera flash during your dive. In order to remove the plate, insert your fingers beneath the
adaptors installed inside the plate and pull the plate upwards till it is removed from its slot.
Note that when photographing using the camera built-in flash only, the flash diffuser
accessory should be installed, or else unwanted shading will occur in most images taken.
c. Make sure the fiber optic cable plate is secured to the housing by its secure line in order to
avoid losing it during the dive.
d. If using only one external flash, make sure the second fiber optic cable adaptor remains in its
place to block any light coming out of the exposed adaptor hole.
area of the frame and for close-up and macro images to be taken.
www.fantasea.com
FRX100 IV Housing Instruction Manual 20150809
7