DRIVESHAFT BEARING HOUSING
• Inspect housing. Replace if cracked or damaged.
• Check condition of oil seals. Replace if nicked, cut or worn.
• Inspect O-ring. Replace if worn, nicked or cut.
Replacing driveshaft oil seal
1. With the oil seal remover, draw the two oil seals out of the
driveshaft bearing housing.
09913-50121 : Oil seal remover
2. Apply Water Resistant Grease to the inner circumference of
the driveshaft bearing housing.
99000-25160 : Water Resistant Grease
3. Grease the inner lips of the seal.
With the lips facing away from driveshaft bearing, place seal
in position and drive it into the bearing housing.
DRIVESHAFT
Inspect driveshaft / splines. Replace if worn, twisted or dam-
aged.
Inspect driveshaft bearing, replace if pitted, noisy or rough.
LOWER UNIT 10-11
Direction of
water pump case