Plans Of Installation - Viking R-6 Installation Instructions And Use & Care Manual

PLANS OF INSTALLATION

PLANS OF INSTALLATION
The gate must be installed in a location so that enough clearance is supplied between the
gate and adjacent structures when opening and closing to reduce the risk of entrapment.
Swinging gates shall not open into public access areas.
Gate in Closed Position
Outside
Inside
The installation shown using the
Straight Arm Secondary Extension can
NOT be back-driven. If a back-driven
installation is required, an Elbow Arm
Secondary Extension can be used.
Contact Viking Access for availability.
*Note: The dimensions provided are
just a guideline. Each site may have
different geometries or possibilities of
installation. The key for installation is
to have "E" longer than "D" and to
adjust the arms such that the arm is
straight at the closed position.
10
C
A B
(min= (min=
11.5) 9.5)
* Set D and E such that the arm is straight when the
gate is closed.
The following are some examples:
A B
13.75 10.5
13.75 10.5
13.75 10.5
13.75 10.5
LONG DISTANCE OR RETROFIT INSTALLATION*
A B
27 10.5
27 10.5
A B
11.5 9.5
11.5 9.5
11.5 9.5
11.5 9.5
Figure A
Plan of Installation
TECHNICAL SUPPORT 1 800 908 0884
B
F
Gate in Open Position
Dimensional Formula
C D
A + 12 * D x 1.45 approx.
NORMAL INSTALLATION*
C D
22 14.75 21.5
26.5 14.75 23.5
26.5 17.75 23.5
39.5 22.5 33.5
C D
35 22.5 29.5
39.5 22.5 33.5
COMPACT INSTALLATION*
C D
18.75 12 17.25
22 13.75 19.5
22 13.75 20
22 14.75 21.5
A
E F
E + 5
E F
23.25
24.25
25
30.5
E F
30
32
E F
19.25
21
21.25
23.5