Fail Safe/Fail Secure Operation; Hold Open Timer - Viking R-6 Installation Instructions And Use & Care Manual

SPECIAL FEATURES SPECIAL FEATURES
2
1
Connection Locations
Fail Safe:
By removing the wire-jumper plug
from the "Fail Safe/Secure" connector:
The gate can be move manually with
relative low amount of force.
Fail Secure:
By inserting the wire-jumper plug into the
"Fail Safe/Secure" connector:
The gate can still be move by hand with
relative high amount of force.
Hold Open Timer
Radio Station
N.O.
The Hold Open Timer function holds the gate at
COM
the open position for a predetermined amount
N.C.
of time, prior to closing automatically.
Set the Timer to the desired time, from 1 to
60 seconds.
If this feature is not needed, turn the Trim
Pot clockwise to the "off" position.
Note: The Hold Open Timer affects the "radio
receiver command" and the sequence of
Motor Sensor
operation for the gate (see page 23).
Low Battery
Power
Charger
TECHNICAL SUPPORT 949-753-1279 TECHNICAL SUPPORT 1 800 908 0884
Fail Safe/Fail Secure Operation
Motor Sensor
The gate operator contains a unique design that
Low Battery
allows the user to move the gate manually in case
of power failure.
Mag.
Lock
Radio UL
Rec. Sensor
COM
N.C.
Mag.
Lock
Power
Radio
Rec.
Charger
1
Loop Connector
2
1sec
Safety Center
Loop Loop
1sec
UL Safety Center
Sensor Loop Loop
Fail
Fail Safe/Secure
Safe/Secure
Open Commands
off 60sec
Open
30sec
Hold Open
Timer
Limit
MAX min.
0
1.5
Obstruction
Overlap Delay
Sensor
off 60sec
Open
30sec
Hold Open
Timer
Limit
MAX min.
0
1.5
Obstruction
Overlap
Sensor
Guard Station
Stop Close
Limit
3
27