Optional Vikingblue™ Wireless Master/Slave Installation - Viking Q-4 Installation Instructions Class Ii, Class Iii, And Class Iv Heavy-Duty Commercial Vehicular Slide Ga

OPTIONAL VIKING BLUE INSTALLATION OPTIONAL VIKING BLUE INSTALLATION
WARNING – Connecting the plug backwards can result in damage to the Control Board
and w w i i l l l l r r e e n n d d e e r r t t h h e e V V i i k k i i n n g g - - B B l l u u e e M M o o d d u u l l e e u u s s e e l l e e s s s s . .
VikingBlue Wireless Master/Slave
1. Decide which Operator will be the Master
and which will be the Slave.
2a. Install the "Master" Viking Blue Module on
the Master Control Board.
2b. Install the "Slave" Viking Blue Module on
the Slave Control Board.
Use care in connecting the plug to the Control
Board. The pins are small and easily bent.
Match the white dot on the plug to the white
dot on the control board (near the JP2 legend
as depicted).
3. Install the Jumper (near the JP3 legend
depicted). Viking-Blue requires this jumper
to operate as a Master/Slave device. The
Obstruction
Sensor
"Low Battery" LED will turn ON, indicating
the Control Board is ready for use with the
Viking-Blue Module.
4. Attach the Viking-Blue Module to the
min. MAX
Operator. For better communication and
performance follow these guidelines:
• The Module must be under the Operator
Cover.
Hold Open
• The Modules must be facing each other as
Timer
much as possible.
Open
The Light on the Viking-Blue module will turn
green upon connection between the other Module.
Be sure to test your Master/Slave communication.
Open Commands Open Commands
Fail
Safe/Secure
Safety Connector Loop Connector
TECHNICAL SUPPORT 1 800 908 0884
Match up
Match up
White Dots
JP2
Match up
White Dots White Dots
JP2
JP2
Install
Install
Jumper
Install
Jumper Jumper
JP3
JP3
Charger Charger
JP3
Power Power
Low Battery
Check Motor
N.C.
COM
N.O.
Radio Station Radio Station
29