Special Features; Auto Open Feature - Viking Q-4 Installation Instructions Class Ii, Class Iii, And Class Iv Heavy-Duty Commercial Vehicular Slide Ga

SPECIAL FEATURES

SPECIAL FEATURES
Auto-Open Feature
The Auto-Open feature in Viking Gate Operators enables the following functionality in
the event of power failure:
a) Open the gate in case of power failure (120 or 220 VAC).
b) Keep the gate at the open position as long as the there is no power.
c) Resume to normal operation when the power has been restored.
The Auto-Open feature allows proper operation while opening in case of power failure
for the following devices:
• All accessories,
• All safety devices,
• All entrapment protections.
The only operation that can not be executed while opening in case of power failure is to
CLOSE the gate.
Fail
Safe/Secure
Safety UL Radio
Loop Sensor Rec.
26
JP3
C35 C36
Brake
Charger Charger
Power Power
Low Battery Low Battery
Check Motor Motor Sensor
Master/Slave Master/Slave
Mag.
Lock
UL
Siren
N.C.
COM
N.O.
Radio Station Radio Station
To enable the Auto-Open feature : Use the
"jumper" provided and place it on the pin-
header of JP3, on the terminals close to C35 as
the illustration indicates.
Overlap Delay
Once you put the "jumper" on the control
board the "Check Motor" light will come on
indicating that the Auto-Open feature has been
enabled.
Close Stop Open
Guard Station Guard Station Open Commands Open Commands
TECHNICAL SUPPORT 1 800 908 0884
Obstruction
Center Safety
Sensor
Loop Loop
min. MAX
Hold Open
Timer
Safety Connector Loop Connector
Fail
Safe/Secure
UL Radio
Sensor Rec.
Mag.
Lock
Radio S Radio S