The Wps Screen - ZyXEL Communications VMG8924-B10A Series User Manual

7.5 The WPS Screen

Use this screen to configure WiFi Protected Setup (WPS) on your VMG.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See
Note: The VMG applies the security settings of the SSID1 profile (see
page
security mode of SSID1 to WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Figure 37 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 22 Network Setting > Wireless > WPS
LABEL
2.4GHz WPS Setup / 5GHz WPS Setup
WPS
Method 1
Connect
Chapter 7 Wireless
Section 7.10.9.3 on page 127
102). If you want to use the WPS feature, make sure you have set the
DESCRIPTION
Use this section to set up a WPS wireless network using Push Button Configuration (PBC).
Select Enable and click Apply to activate WPS method 1 on the VMG.
Click this button to add another WPS-enabled wireless device (within wireless range of the
VMG) to your wireless network. This button may either be a physical button on the outside
of device, or a menu button similar to the Connect button on this screen.
Note: You must press the other wireless device's WPS button within two minutes of pressing
this button.
VMG8924-B10A and VMG8924-B30A Series User's Guide
for more information about WPS.
111
Section 7.2 on