The Quality Of Service General Screen - ZyXEL Communications VMG8924-B10A Series User Manual

which are performed on the colored packets. See
each metering algorithm.

10.3 The Quality of Service General Screen

Click Network Setting > QoS > General to open the screen as shown next.
Use this screen to enable or disable QoS and set the upstream bandwidth. See
page 159 for more information.
Figure 70 Network Settings > QoS > General
The following table describes the labels in this screen.
Table 46 Network Setting > QoS > General
LABEL
QoS
WAN Managed
Upstream
Bandwidth
Chapter 10 Quality of Service (QoS)
DESCRIPTION
Select the Enable check box to turn on QoS to improve your network performance.
Enter the amount of upstream bandwidth for the WAN interfaces that you want to allocate
using QoS.
The recommendation is to set this speed to match the interfaces' actual transmission speed.
For example, set the WAN interfaces' speed to 100000 kbps if your Internet connection has
an upstream transmission speed of 100 Mbps.
You can set this number higher than the interfaces' actual transmission speed. The VMG
uses up to 95% of the DSL port's actual upstream transmission speed even if you set this
number higher than the DSL port's actual transmission speed.
You can also set this number lower than the interfaces' actual transmission speed. This will
cause the VMG to not use some of the interfaces' available bandwidth.
If you leave this field blank, the VMG automatically sets this number to be 95% of the WAN
interfaces' actual upstream transmission speed.
VMG8924-B10A and VMG8924-B30A Series User's Guide
Section 10.7 on page 171
161
for more information on
Section 10.1 on