Table of Contents
Advertisement
Table 13 Wireless > More AP: Edit (continued)
LABEL
Wireless Network
Name (SSID)
Hide SSID
BSSID
Security Level
Security Mode
Apply
Back
5.4 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your LTE Device.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See
Note: The LTE Device applies the security settings of the SSID1 profile (see
on page
security mode of SSID1 to WPA-PSK, WPA2-PSK or No Security.
LTE-5121 User's Guide
DESCRIPTION
The SSID (Service Set IDentity) identifies the service set with which a
wireless device is associated. Wireless devices associating to the access
point (AP) must have the same SSID.
Enter a descriptive name (up to 32 English keyboard characters) for the
wireless LAN.
Select this check box to hide the SSID in the outgoing beacon frame so a
station cannot obtain the SSID through scanning using a site survey tool.
This shows the MAC address of the wireless interface on the LTE Device
when wireless LAN is enabled.
Select Basic (WEP) or More Secure (WPA(2)-PSK, WPA(2)) to add
security on this wireless network. Wireless clients must use the same
wireless security settings as the LTE Device to connect to the wireless LAN.
After you select to use security, additional options appears in this screen.
Or you can select No Security to allow any client to connect to this network
without any data encryption or authentication.
See
Section 5.2.1 on page 47
Click Apply to save your changes.
Click Back to exit this screen without saving.
Section 5.8.6.3 on page 65
45). If you want to use the WPS feature, make sure you have set the
for more details about this field.
for more information about WPS.
Chapter 5 Wireless
Section 5.2
53
Advertisement
Table of Contents
