Table of Contents
Advertisement
3. Using the measurements obtained in
step 2, make horizontal marks on the
aiming surface.
4. Make vertical marks which intersect
the horizontal marks on the aiming
surface directly in front of the head-
lights.
5. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
6. Observe each headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical mark
5 cm (2 in.) below the horizontal
mark on the aiming surface.
7. Adjust each headlight by turning the
adjustment knob clockwise to raise
the beam or counterclockwise to
lower the beam until correct aim is
obtained.
Fuses
The fuses are located in a fuse block
under the seat. If there is any type of
electrical system failure, always check
the fuses first.
NOTE: To remove the fuse, com-
press the locking tabs on either
side of the fuse case and lift out.
Always replace a blown fuse with a
fuse of the same type and rating. If
the new fuse blows after a short
period of use, consult an authorized
Arctic Cat ATV dealer immediately.
Electrical Output
Terminals
One output terminal for electrical acces-
sories is located on the front wiring har-
ness.
Two output terminals for electrical acces-
sories are located on the front and rear
wiring harnesses. The accessory plug is
located on the right side of the instrument
pod.
CD714A
Always use electrical accessories
less than 180W.
Tool Storage Tray/
Storage Compartment
A basic tool kit is provided with the ATV.
Maintain the tool kit with the ATV at all
times.
The tool storage tray is located beneath
the seat.
CAUTION
CAUTION
1411-381
DE034
69
Advertisement
Table of Contents
