8
Controlling the VP-773A
The VP-773A can be controlled via:
The front panel buttons (see
The OSD menu (see
The Web pages (see
The infrared remote control transmitter (see
8.1
Controlling via the Front Panel Buttons
The VP-773A includes the following front panel buttons:
Input selector buttons for selecting the required input: HDMI (1 to 4), PC
(1 and 2), CV and DP (see
PIP, BLANK and FREEZE buttons (note, these buttons illuminate when
selected)
MENU (left arrow), ENTER (right arrow), and up, down, arrow buttons
Output volume up (+) and down (-) buttons (when not in the OSD mode)
RESET TO XGA/720p and PANEL LOCK buttons
8.1.1
Using the INPUT Front Panel buttons
When selected, an INPUT front panel button behaves as follows:
Selecting the:
Main input button
PiP input button
Same Main input button and
PiP button
8.2
Controlling via the OSD Menu
You can change PiP Window parameters, main window parameters and entire
system parameters via the OSD menu, as described in
46
Section
Section
Illuminate continuously
Blink (the light On period is shorter than the light Off period)
Blink (the light On period is longer than the light Off period)
If you want to adjust the image of a selected input in a window, press
that input button again (up to 3 times) for fast tuning. Pressing that
input button for the fourth time initiates full tuning of the window.
Section
8.1)
8.2)
8.3)
Section
Section
8.1.1)
Causes the button to:
VP-773A - Controlling the VP-773A
8.4)
Section
6.8.