Checking And Replacing The Main Fuse - Invacare Storm4 Max Service Manual

® 4
Invacare - STORM
7.3.4

Checking and replacing the main fuse

CAUTION: Fire hazard!
 Always use an original strip fuse with the approved amperage.
 If the main fuse has blown, first rectify the cause before fitting a new one.
CAUTION: Fire hazard!
Fitting the incorrect strip fuse causes a fire hazard!
 Only fix the strip fuses in the sequence shown in the image on the right!
 Tighten the nuts with 3.3 or 3.5 Nm!
Requirements:
 8 mm socket spanner
Note
If the fuseholder is damaged, you can replace this complete with the battery cables.
Dismantling the main fuse:

Remove the battery compartment cover, disconnect the battery plugs and pull the batteries out
of the battery compartment as described in chapter 7.3.1.

The fuseholder (1) is located on top of the batterie.

Open the fuseholder cover.
MAX SERVICE MANUAL
1. Strip fuse
2. Spade terminal
3. DIN 6923 nut
49