Checking And Replacing The Main Fuse - Invacare Kite Series Service Manual

®
Invacare - Kite
8.5

Checking and replacing the main fuse

CAUTION: Fire hazard!
· Always use an original strip fuse with the approved amperage.
· If the main fuse has blown, first rectify the cause before fitting a new one.
CAUTION: Fire hazard!
Fitting the incorrect strip fuse causes a fire hazard!
· Only fix the strip fuses in the sequence shown in the image on the right!
· Tighten the nuts with 3.3 or 3.5 Nm!
Requirements:
· 8 mm socket wrench
· 11 mm socket wrench
· 80 A strip fuse
Note
If the fuseholder is damaged, you can replace this complete with the battery cables.
Dismantling the main fuse:
·
Switch the electronics OFF on the remote.
·
Remove the rear battery, as described in chapter 8.4.
·
The fuse holder is located on top of the rear battery.
·
Open the fuseholder cover.
·
You see the strip fuses (2) once the fuse holder (1) is open.
·
If the strip fuse has blown, you must first ascertain and rectify the cause of the fault.
SERVICE MANUAL
· 1. Strip fuse
· 2. Spade
terminal
· 3. DIN 6923 nut
49