7.6
Checking and replacing the main fuse
CAUTION: Fire hazard!
A short circuit can cause extremely high currents which can result in spark formation and
fire!
• Always use an original strip fuse with the approved amperage.
• If the main fuse has blown, first rectify the cause before fitting a new one.
CAUTION: Fire hazard!
Fitting the incorrect strip fuse causes a fire hazard!
• Only ever assemble the fuse in the order shown in the
illustration at right!
• Always tighten nuts to between 3.3 and 3.5 Nm!
Pre-requisites:
• 8mm open-ended spanner
• 40A strip fuse
Information
If the fuse holder is damaged this can be replaced completely together with the battery cables.
•
Remove the battery cover.
Until 03.2004
After 03.2004
1. Fuse
1. Fuse
2. Fuse compartment
2. Fuse compartment
3. Washer
3. Nut DIN 6923
4. Nut M5
37