Electronics; Checking And Replacing Main Fuse - Invacare Stream Service Manual

Hide thumbs Also See for Stream:
Table of Contents

Advertisement

8. Install tyre in reverse order.
9. Apply rim halves to wheel.
10. Inflate tyre a little.
11. Place screws in wheel rim and tighten screws with prescribed torque. Make sure that inner tube is not clamped
between wheel rim halves.
12. Make sure that tyre is contacting wheel rim directly.
13. Inflate tyre to prescribed pressure.
14. Make sure that tyre is still closely contacting wheel rim.
15. Screw valve cap on.
16. Install wheels according to instruction. See respective chapter.
Repairing Solid Tyre
6 mm Allen key
3 joiner's clamps with plastic caps
Risk of Damage to Rim Threads
Incorrectly tightened screws can cause damage to rim threads.
– Tighten rim screws with prescribed tightening torque.
1. Remove wheel as described in respective chapter in this manual.
2. Secure rim halves against unexpected discharge with three joiner's clamps. When doing so, make sure that you
do not scratch rims.
3.
Loosen and remove screws (2) on inside of wheel.
4. Loosen joiner's clamps carefully and alternately until you can remove rim halves without risk.
5. Remove inner (3) and outer (1) half of rim from tyre (4).
6. Replace any defective or worn parts.
7. Install tyre in reverse order.
8. When fitting rim halves together, make sure that drill holes and threads for screws are placed exactly on top of
each other.
9. Place joiner's clamps in position.
10. Tighten joiner's clamps alternately in small stages until rim halves are precisely aligned.
11. Install and tighten screws.
12. Remove joiner's clamps.
13. Install wheel as described in respective chapter in this manual.

6.8 Electronics

6.8.1 Checking and replacing main fuse

WARNING!
Risk of fire
A short circuit can cause extremely high currents which can result in spark formation and fire.
– Always use an original strip fuse with the approved amperage.
– If the main fuse has blown, first rectify the cause before fitting a new one.
8 mm wrench
60A plug-in fuse
If fuse holder is damaged it can be replaced completely together with battery cables.
1608312-B
Fig. 6-14
Service
29

Advertisement

Table of Contents
loading

Table of Contents