Checking And Replacing Main Fuse - Invacare Kite Series Service Manual

3.
Disconnect battery cable from power module.
4. Loosen and remove screws (4).
5. Loosen and remove screws (2).
6. Turn rear shroud (1) down along with power modules.
7.
Pull foam block (3) backwards out of battery box.
8. Pull off terminal caps (2) of both battery terminals (1).
9. Loosen and remove battery terminal screws.
10. Remove battery cable.
11. Pull battery (3) out onto rear shroud by its belt (4).
12. Remove battery.
13. Pull second battery towards you by its belt and repeat previous steps.
Installing Batteries
1. Install batteries in reverse order.
2. Make sure battery box sockets and plugs are correctly installed. A diagram showing how to connect battery terminals
correctly can be found in rear shroud.

6.11.4 Checking and Replacing Main Fuse

CAUTION!
Risk of fire
A short circuit can cause extremely high currents which can result in spark formation and fire.
– Always use an original strip fuse with the approved amperage.
– If the main fuse has blown, first rectify the cause before fitting a new one.
CAUTION!
Risk of fire and burns
Fitting incorrect strip fuse causes fire hazard.
– Only fix strip fuses in sequence shown in image below.
– Tighten nuts with 3.3 or 3.5 Nm.
1552415-K
Fig. 6-52
Fig. 6-53
Service
51