Replacing The Seat Support With Electric Tilt Module - Invacare Storm4 Max Service Manual

SERVICE MANUAL
7.6.5

Replacing the seat support with electric tilt module

CAUTION: Danger of crushing!
 The seat/seat support are very heavy. You should seek help from a second person who can
secure the seat and help when carrying.
Requirements:
 T40 torx wrench
 oblique pliers
 cable ties
Dismantling the seat support:

Remove the legrests.

Remove the armrests.

Remove the seat cushion.

Remove any existing cable ties holding the cables on the remote or lighting. Remove the
cables from the stuck on clamps.

Loosen the cap nuts of the headlight mountings using an 8 mm jaw spanner (see
chapter 7.2.3).

Put the headlight and the mounting in a safe place on the rear part of the battery compartment
cover.

Remove the connecting cable to the chassis from the remote or form the optional actuator
module.

Remove the cable or cables so that there is no longer any cable connection between the seat
and the chassis.

Remove the pin retainer (1).

Remove the bolt (2).
70
® 4
Invacare - STORM MAX