SERVICE MANUAL
7.12
Fitting the headrest
7.12.1 Fitting the headrest to the standard back
Requirements:
5 mm Allen key
10 mm socket spanner
Gripping it at the base, hold the lower section of the headrest mounting (4) with the clamp
block against the handlebar (3).
Attach the clamp cover (2.
Insert the four Allen screws (1) from above through the boreholes.
Fit the four cap nuts (5) to the screws from underneath.
Use a 5 mm Allen key and a 10 mm socket spanner to tighten the screws and the cap nuts.
Fit the headrest in the guide bar.
86
®
4
Invacare
- STORM
MAX