Propeller Governor; Take-Off Climb - Rotax 912 i series Operator's Manual

Performance
Propeller gover-
nor
3.7) Take-off
Safety
Climb
3.8) Cruising
Oil temperature
Effectivity: 912 i Series
OM Edition 1/Rev. 2
Step
1 Set performance as per performance specifications
ter 5) and respect operating limits as per
2 Carry out performance checks in accordance with the air-
craft manufacturer regulations.
Check of hydraulic propeller governor:
Check control of the hydraulic propeller governor to specifications
of the manufacturer.
NOTE:Cycling the propeller governor puts a relatively high load on
the engine. Unnecessary cycling should be avoided.
WARNU
WARNING
Observe the monitor oil temperature, oil pressure (LANE se-
-
lect switch B has to turned "ON") and coolant temperature
(LANE select switch A has to turned "ON"). Limits must not
be exceeded! See
- Respect "cold weather operation" recommendations, see
Chapter 3.10).
Climbing with engine running at take-off performance is permissi-
ble (max. 5 minutes) (see
Step
1 Avoid operation below normal operation oil temperature
(90 to 110 °C/194 to 230 °F), as possible formation of con-
densation water in the lubrication system badly influences
the oil quality.
To evaporate possibly accumulated condensation water,
at least once a day 100 °C (212 °F) oil temperature must
be reached.
BRP-Powertrain
Procedure
Non-compliance can result in serious injuries
or death!
Chapter 2.1) Operating limits.
Chapter 2.1).
Procedure
Chap-
Chapter 2.1).
page 3-13
April 01/2014