Slant/Slope Fine Adjustment Mode - ADA INSTRUMENTS 6D SERVOLINER Operating Manual

Line laser level

Table of Contents

Available languages

Slant/slope fine adjustment mode

1. After power on� pressing "power �utton" (8) for a little �it time enter (or quit) "slant / slope fine adjustment mode"

2. Setting "slant fine adjustment [X axis]" for start point.

3. �uring the time of "slant fine adjustment [X axis]"� pressing �� can �e switched to "angle of slope in horizontal plane" (left).

�uring the time of "slant fine adjustment [X axis]"� pressing �� can �e switched to "angle of slope in horizontal plane" (left).

4. �uring the time of "slope fine adjustment [Y axis]"� pressing �� can �e switched to "slope of horizontal plane"

5. Bi-Bi sound mentions that you've reached the limit of slope position.

pressing �� can �e switched to "angle of slope in horizontal plane" (left).

pressing �� can �e switched to "slope of horizontal plane"

SERVOLINER

/ slope fine adjustment mode"

slope fine adjustment mode"

MEASUREMENT FOUNDATION

Table of Contents

Table of Contents

Do you have a question about the 6D SERVOLINER and is the answer not in the manual?